Flip chips can be easily misplaced. That's where this kit comes to the rescue.

The Ripmo V3 and Ripley V5 utilize a set of flip chips in the swingarm to adjust for rear wheel size. The flip chip position is clearly marked on the swingarm and should always match the rear wheel size installed. A mismatch between the flip chip position and rear wheel size will negatively impact the bike's geometry.

The flip chip bolt has a 15nm torque spec. Ensure the bolt threads are treated with Loctite 243 or that a green thread patch is present.

NZ Delivery Only

Replacement axle for models with the UDH.

Length 174mm

Thread Pitch 12x1.0

Torque to 10nm

43 grams

If you want to mount a chain guide on your Ibis, you will need one of these.

When using SRAM DUB cranks along with the ISCG plate on a RipMo or any frame with a 73mm bottom bracket shell width, you will need the SRAM DUB 2mm spacer inside the drive side crank arm against the bottom bracket shell.

It's aluminum. ISCG 05 standard

NZ delivery only.

Replacement hanger for UDH models.

Includes fixing bolt and washer.

26 grams

Note: the washer is required to install on to the frame. Damage will occur if a hanger is mounted without the washer under the main fixing bolt.

This is for the Lower / Rear eyelet that connects to the clevis.

15mm wide with an 8mm bore

Fits following models:

• Alloy Frames

• Exie

• HD6, HD5, HD4

• Mojo 3, Mojo 4

• Ripley 4

• Ripley V4S

• Ripley V5

• Ripmo 1-2

• Ripmo V2S

• Ripmo V3

Included in the 4 piece kit is an eyelet bushing, black-ano rod, and two plastic spacers.

NZ delivery only.

Ibis Logo T-Shirt
Size: XL
Colour: Orange with Black Ibis logo
Cotton Polyester

NZ delivery only.