It takes a lot of time and effort, but the bearings on the Upper Link can wear out. This is a replacement upper link for the HD6

Details:

• Forged Aluminum 6061-T6

• CNC machined

• Anodized finish

• Includes bearings

• Bolt kit sold separately

NZ delivery only.

Replacement bearings for the upper swingarm pivot point of the HD6.

Details:

• Two custom spec bearings specifically made for use as pivot bearings

• Extra tight seal rings to hold in a 100% fill of waterproof grease

This is the kit to replace your entire lower link assembly on the Ripmo V3, Ripley V5, and HD6.

All the hardware and replacement bushings / o-rings are included.

This link is wider than previous bushing models, the 71mm etching notes that it is the wider link kit for the Ripmo V3/Ripley V5/HD6 only.

Replacement axle for models with the UDH.

Length 174mm

Thread Pitch 12x1.0

Torque to 10nm

43 grams

Replacement hanger for UDH models.

Includes fixing bolt and washer.

26 grams

Note: the washer is required to install on to the frame. Damage will occur if a hanger is mounted without the washer under the main fixing bolt.

This is for the Lower / Rear eyelet that connects to the clevis.

15mm wide with an 8mm bore

Fits following models:

• Alloy Frames

• Exie

• HD6, HD5, HD4

• Mojo 3, Mojo 4

• Ripley 4

• Ripley V4S

• Ripley V5

• Ripmo 1-2

• Ripmo V2S

• Ripmo V3

Included in the 4 piece kit is an eyelet bushing, black-ano rod, and two plastic spacers.

NZ delivery only.

Finally putting the Ride More Work Less logo to good use, this handy flask will safely house the fine contents of any tasty beverage. Made of 18/8 grade stainless and holds 4oz of goodness. UV cured printed logo.

NZ delivery only.